Table of Contents
Advertisement
7
7-5.
CCU-700A/ 700AP, Camera Control Unit
Chapter 7 Location and Function of Parts and Controls
70
BVP-E10 Series Product Information Manual
7-5-1
Front Panel
2Green tally lamp
1Red tally lamp
1
CABLE
ALARM
SHORT OPEN
MAIN
POWER
I
O
8CABLE ALARM indicator
7MAIN POWER switch and
indicator
a Red tally lamp
a
a
a
Illuminates when the unit receives a red tally signal.
When the CALL button on the video camera, MSU-
700A Master Setup Unit, or RCP-700 Series Remote
Control Panel is pressed, the lamp lights if it is not lit,
or goes dark if it is lit. Attach a supplied number plate
here.
b Green tally lamp
b
b
b
Illuminates when the unit receives a green tally signal.
Attach a supplied number plate here.
c MIC (microphone select) switch
c
c
c
Set to the appropriate position according to the type of
the headset microphone.
DYNAMIC: To use a dynamic microphone
OFF: To cut off a microphone signal
CARBON: To use a carbon (or carbon equivalent)
microphone.
The intercom line can be switched with the
corresponding switch on the internal AT board.
d INTERCOM (intercom volume) control
d
d
d
Adjusts the receiving level of the intercom. The volume
of the sound mixed with programme audio is set with
the control on the internal AT board.
e INTERCOM connector (XLR 5-pin)
e
e
e
Connect a headset. When you wish to use a headset
with a plug other than XLR 5-pin type, consult an
authorized Sony representative.
f CAMERA POWER switch and indicator
f
f
f
This switch controls the power supply to the video
camera when the MAIN POWER switch is set to the ON
side (I position). The indicator illuminates when power
is supplied to the video camera.
If an RCP-700 Series Remote Control Panel is
connected to this unit, the CAM PW switch on the panel
must be lit for control of the power supply to the
camera with this switch to be enabled.
g MAIN POWER switch and indicator
g
g
g
This switch turns on and off the power supply to the
entire camera system including this unit, a BVP-700/
750/500/550-series Color Video Camera, and an RCP-
700 Series Remote Control Panel connected to the
REMOTE connector. The indicator illuminates when
power is supplied to the system.
3MIC switch
4INTERCOM control
1
DYNAMIC
MIC
OFF
CARBON
CAMERA
POWER
INTERCOM
I
O
5INTERCOM connector
6CAMERA POWER switch and indicator
h CABLE ALARM indicator
h
h
h
SHORT: Illuminates when there is a current
overload in the triax cable or when there is a short-
circuit in the unit.
OPEN: Illuminates when no triax cable is connected
to the CAMERA connector on the rear panel, when
there is a faulty connection, or when load current is
extremely low even if a camera cable is connected.
CAMERA CONTROL UNIT
Advertisement
Table of Contents
