Table of Contents
Advertisement
7-15.RM-B750, Hand-held Remote Control Unite
7-15-1Operation Panel
a Memory Stick slot
a
a
a
Insert a Memory Stick media card to store setup data,
such as reference files and scene files of the video
camera or camera control unit.
b MEMORY STICK (Memory Stick access) lamp
b
b
b
The lamp shows the status of the Memory Stick media
card.
Off: No Memory Stick is inserted.
Lit green: There is a Memory Stick in the slot. In this
condition, you can safely eject the Memory Stick.
Lit red: Data is being read/written. If you eject the
Memory Stick in this condition, the data transfer is
not guaranteed. All the data may be lost.
c
c PANEL ACTIVE button
c
c
Press to select the control mode for the connected
camera system. Each time you press the button, the
control mode cyclically switches among FULL, PART,
and LOCK modes*.
FULL mode: All controls from this unit are enabled
(panel active status). Both this button and the IRIS/
MB ACTIVE indicator in the iris/master black
control block light.
PART mode: Controls only from the iris/master
black control block are enabled (iris/master black
active status). This button goes dark, but the IRIS/
MB ACTIVE indicator stays lit.
LOCK mode: All controls from this unit are disabled
(lock status). Both this button and the IRIS/MB
3 PANEL ACTIVE button
4 STANDARD button
2 MEMORY STICK lamp
1 Memory Stick slot
Rubber cap
PANEL
STANDARD
ACTIVE
MEMORY
STICK
MONITOR
FUNCTION
VF DISP
MAINTENANCE
VF MENU
SCENE
CANCEL
PAINT
ENTER
ALARM
MENU SELECT
qa Menu operation block
q; ALARM indicator
5 Spare button
6 Test signal output select buttons
7 CLOSE button
8 VTR START/STOP button
TEST
BARS
CLOSE
VTR
START/STOP
ABB
AWB
WHITE
BLACK
IRIS/MB
AUTO
ACTIVE MASTER
IRIS
BLACK
EXT
IRIS
REMOTE CONTROL UNIT RM-B750
qs Iris/master black control block
ACTIVE indicator in the iris/master black control
block go dark.
*Using the RM Configuration menu under the Maintenance
menu, the function of this button can be changed to switch
only between FULL and LOCK modes. The RM
Configuration menu operation is possible in any mode.
d
d STANDARD button
d
d
When you press this button, the video camera is
initialized to its standard state, and the button
illuminates for several seconds. If you press the button
while lit, the video camera returns to the state before
the button was originally pressed.
e
e Spare button
e
e
For future use.
f Test signal output select buttons
f
f
f
Press and light up one of these buttons to activate the
test signal generator of the video camera and send the
respective signals.
TEST: To send a signal to test the video circuits.
You can select the kind of the test signal to be
output using the RM Configuration menu under the
Maintenance menu.
BARS: To send a colour bar signal
Note:
The BARS button takes priority to the TEST button. If
the BARS button is lit, press the button to switch it off
before pressing the TEST button.
Chapter 7 Location and Function of Parts and Controls
BVP-E10 Series Product Information Manual
9 VTR playback
control buttons
qd White balance/black
balance control block
107
Advertisement
Table of Contents
