Table of Contents
Advertisement
7
7-17.BVF-55/ 55CE, Electronic Viewfinder
Chapter 7 Location and Function of Parts and Controls
112
BVP-E10 Series Product Information Manual
7-17-1Appearances
1G TALLY lamp
8PEAKING switch
and knob
7BRIGHT knob
6CONTRAST knob
a G TALLY lamp (green)
a
a
a
Illuminates when the green tally signal is input.
b R TALLY lamp (red)
b
b
b
Illuminates when the red tally signal is input.
c
c Up-tally lamp (red)
c
c
Set UP TALLY switch to ON. The lamp illuminates in the
same way as the R tally lamp. The supplied number
plate can be attached to this.
d Tilt lock lever
d
d
d
Fixes any tilting position.
e 12-pin connector
e
e
e
Connects to a video camera's VF connector, using the
supplied connecting cable.
Power and video/tally signals are supplied through this
connector.
2R TALLY lamp
f CONTRAST knob
f
f
f
Adjusts the contrast of the viewfinder picture.
g BRIGHT knob
g
g
g
Adjusts the brightness of the viewfinder picture.
h PEAKING switch and knob
h
h
h
Setting this switch to ON and turning the knob
increases the sharpness of the viewfinder image. Used
to assist the focus on the video camera. The peaking
control can be turned off by a control signal sent from
the camera even if the PEAKING switch is set to ON.
i Tilt knob
i
i
i
Adjusts the tilt friction.
j UP TALLY switch
j
j
j
When this switch is set to ON, the UP TALLY lamp
illuminates in the same way as the R tally lamp.
3Up-tally lamp
4Tilt lock lever
512-pin connector
9Tilt knob
q;UP TALLY switch
qaUP TALLY DIMMER control
*1)
*1)
*1)
Advertisement
Table of Contents
