Table of Contents
Advertisement
8
Chapter 8 Menu Settings
122
BVP-E10 Series Product Information Manual
Engineer Protection
Protection
Code
Enable
Code
Delete
3.
To temporarily disable the security code, press
[Code Enable] to change it from inverse video to
unhighlighted display. (Once you press it again to
return it to inverse video, the security code is
enabled.)
4.
To delete the security code, press [Code Delete].
The message "Code Delete, OK?" is displayed,
press [OK] to return to the Engineer Protection
display.
5.
Press [Exit].
Note
At the factory, the unit is set in a mode in which
no security code is used.
8-1-2
Setting the Security Status
When in the Engineer Mode, it is possible to set
restrictions which limit control capability of the MSU-
700A/750 in the normal operational mode.
Operation
Proceed as follows:
Menu operation block(Example:MSU-700A)
Configuration Menu
MODE
Configuration Menu
Camera
CCU
MULTI
CNU
MSU
1
CARD
CONFIG
MAINTENANCE
FILE
PAINT
1.
Press to light the CONFIG button.
2.
Press [MSU]. The MSU Configuration Menu
appears.
MSU Configuration
Exit
MSU
MSU SW
Adjusting
Set
Date /
Time
3.
Press [Security]. The Security Menu display
appears.
Security Menu
4.
Press [Engineer Mode]. The numeric keys and
field for entering the Code No. are displayed.
Code No:
2
5.
Enter the security code using the numeric keys,
then press [OK].
Note
Each digit you input will be displayed as an
asterisk. The Security Menu items now appear.
Security Menu
Engineer Mode
Code
Status
Change
Exit
Security
Exit
Engineer Mode
Engineer Mode
7
8
9
4
5
6
1
2
3
0
OK
Cancel
Exit
Engineer Mode
Advertisement
Table of Contents
