Table of Contents
Advertisement
7-4.
CCU-550D/ 550DP, Camera Control Unit
7-4-1
1Camera number/tally indicator
a Camera number /tally indicator
a
a
a
Illuminates red when the red tally signal is input (e.g.
when the video signal from the video camera
connected to the CCU-550D/550DPCCU-550D/550DP
goes on air). When the CALL button on the video
camera, MSU-700A/750, RCP-700 Series remote
control panel, or an optional BKP-5973 is pressed, he
indicator lights if it is not lit, and goes off if it is lit. the
indicator lights green when the green tally signal is
input. Attach the appropriate number from the
supplied number sheet here to indicate the camera
number.
b POWER switch/CAM (camera) and MAIN
b
b
b
indicators
The POWER switch turns on or off the power supply to
the entire camera system, including the CCU-550D/
550DPCCU-550D/550DP, the video camera, and the
remote control unit connected to the REMOTE
connector on the CCU-550D/550DPCCU-550D/
550DP. The MAIN and CAM indicators light when the
POWER switch is turned on. The CAM indicator goes
off when the power is turned off by the CAM PW button
on the remote control panel or the master setup unit, or
CAM POWER switch on the internal AT board.
Note
If the fan in the CCU-550D/550DP stops, the MAIN and
the CAM indicators will flash simultaneously to warn
you of the abnormal condition. If this occurs, turn the
POWER switch off immediately and contact Sony
service personnel.
c CABLE ALARM indicators
c
c
c
OPEN: Illuminates when no triax cable is
connected to the CAMERA connector on the rear
panel of the CCU-550D/550DP, or when the load
current is extremely low even when a camera cable
is connected.
SHORT: Illuminates when there is a current
overflow in the triax cable.
Front Panel
2POWER switch/CAM and MAIN indicators
POWER
CABLE
ALARM
CAM
OPEN
MAIN
?
SHORT
1
INCOM
MIC –
ON
PROD
OFF
PREV
PGM
PGM
4INCOM input/output/setting section
3CABLE ALARM indicators
d
d INCOM (intercom) input/output/setting section
d
d
INCOM (intercom) connector (XLR, 5-pin)
Connects a headset. When you wish to use a headset
with a plug other than XLR 5-pin type, consult Sony
service personnel.
INCOM level control
Adjusts the volume level of the intercom.
MIC/PGM (programme audio) switch
ON: Turns on the headset microphone.
OFF: Turns off the headset microphone.
PGM: Outputs the programme audio. When this
position is selected, the INCOM level control
adjusts input level of the programme audio.
INCOM selector
Selects the pathway of intercom signals output/input
through the INCOM/TALLY/PGM connector.
PROD: Producer line.
PRIV: Producer line and engineer line are cut off
and communication is possible only between the
CCU-550D/550DP and the camera connected to
the rear panel of the CCU-550D/550DP.
ENG: Engineer line.
Chapter 7 Location and Function of Parts and Controls
BVP-E10 Series Product Information Manual
67
Advertisement
Table of Contents
