Table of Contents
Advertisement
7
Chapter 7 Location and Function of Parts and Controls
84
BVP-E10 Series Product Information Manual
R, G, and B signals in sequence on a waveform
monitor.
ENC (encode): When this button is pressed, the R/
G/B and SEQ circuits are turned off, and the ENC
signal is output.
1
2
PARA
MULTI
TALLY
PANEL
ACTIVE
1
EXPAND
7
A PANEL ACTIVE button
Press and light up this button to permit the
cameras selected with the camera select
buttons to be controlled from this unit. The IRIS/
MB ACTIVE button also lights up. If you press
the button when lit, it goes dark and the
operation panel of this unit is locked.
B PARA (parallel mode) button
Press and light up this button to activate Parallel
mode, which enables concurrent operation with
another control panel. If you press the button
when lit, it goes dark and Parallel mode is
canceled.
C MULTI indicators
Show the Master/Slave status of the
corresponding cameras 1 through 12 (when the
EXPAND button is not lit) or 13 through 24 (when
the EXPAND button is lit).
The indicator for the camera that is specified as
the master for Master/Slave mode lights green.
The indicators for the slave cameras light
orange. They light red during the auto setup of
the corresponding cameras. If an error occurs
during the auto setup and the operation is
interrupted, they will flash red.
D TALLY indicators
Show the tally status of the corresponding
cameras 1 through 12 (when the EXPAND
button is not lit) or 13 through 24 (when the
EXPAND button is lit). The corresponding
indicator illuminates red when a red tally is sent
to a camera, and it illuminates green when a
green tally is sent. When both red and green
tally are sent, it illuminates orange. When a call
signal is sent to the camera, the indicator rapidly
flashes in red.
E Active indicators
Show the control status of the corresponding
cameras 1 through 12 (when the EXPAND
button is not lit) or 13 through 24 (when the
EXPAND button is lit). The indicators for the
cameras under control of this unit light green
and the indicators for the cameras under control
of another control panel light orange. An
indicator whose corresponding camera (or
camera control unit) is not connected does not
light. An indicator lights red when an error is
detected and the self-diagnostic functions are
activated in the corresponding camera or
camera control unit.
F Camera select buttons
Select the cameras to be controlled from this
unit. Press and light up the button
corresponding to each desired camera.
Cameras 1 through 12 are selected when the
EXPAND button is not lit, and cameras 13
n Camera select block
n
n
n
2
3
4
5
6
7
6
through 24 are selected when the EXPAND
button is lit.
G EXPAND button
Press to select the group to be selected with the
camera select buttons. Cameras 1 through 12
can be selected when this button is not lit, and
cameras 13 through 24 can be selected when
this button is lit.
Note
An appropriate camera command network unit
(CNU- 700, etc.) is required to control multiple
cameras using the camera select function.
o
o Filter control block
o
o
FILTER CTRL
A FILTER CTRL (filter control) button
Press and light up the button to enable filter
selection with the CC and ND filter select
buttons of this unit.( Only applies to cameras
with remote control of filter wheels, eg BVP-
E10WS/WSP)
B ND (ND filter select) buttons
While the FILTER CTRL button is lit, press and
light up one of these buttons to select the
corresponding ND filter.
Actual filter depends on camera model. For
BVP-E10 Series, the following filters are used
[1] Clear
[2] 1/4 ND
[3] 1/16 ND
[4] 1/64 ND
[5] Not available
When the FILTER CTRL button is not lit, the
button corresponding to the filter selected at the
video camera illuminates.
C CC (colour temperature conversion filter select)
buttons
While the FILTER CTRL button is lit, press and
light up one of these buttons to select the
corresponding CC filter.
Actual filter depends on camera model. For
BVP-E10WS/WSP cameras, the following
filters are used
[1] Cross filter
[2] 3200K (clear)
3
4
5
8
9
10
11
12
1
2
1
2
3
4
5
ND
A
B
C
D
E
CC
3
Advertisement
Table of Contents
