Front Panel - Sony BVP-E10 Series Product Information Manual

7
Chapter 7 Location and Function of Parts and Controls
60
BVP-E10 Series Product Information Manual
7-1-2

Front Panel

VF
AUTO W/B BAL
WHT
SHUTTER
OFF
ON
BLK
VTR START
SEL
MIC
LEVEL
7SHUTTER switch
8VTR START button
9LENS connector
q;MIC connector
a VF (viewfinder) connector (20-pin) a
a a
Connect the 20-pin viewfinder cable of the BVF-10/
10CE/ 20W/ 20WCE viewfinder.
b b Cable clamp b b
Secures a microphone cable and lens cable.
c Lens mount lever c
c c
Secures the lens to the lens mount.
d AUTO W/B BAL (automatic white balance/ black d d d
balance adjustment) switch
Adjusts the white balance and black balance
automatically.
WHT: The white balance is automatically adjusted.
When the WHITE BAL switch on the side of the
camera is set to A or B, the adjusted value is stored
in memory cell A or B.
BLK: The black balance is automatically adjusted.
The black set is simultaneously adjusted.
Note:
The SHUTTER and AUTO W/B BAL switches do not
function when the camera is connected to a CCU,
RCP, or RM.
e e MENU SELECT knob e e
When the DISPLAY switch on the side panel is set to
MENU and the menu is displayed, turn this control to
select a menu item and press it to register the
selection.
f MIC LEVEL (microphone level) control f
f f
When a portable VTR is connected using the CCZ
cable of the CA-570/570P Camera Adaptor, the
microphone level can be adjusted by turning this
control. When the CA-570/570P Camera Adaptor is
used and the LEVEL/ MIC switch on the rear panel of
the camera adaptor is set to FRONT/OFF, the sound
volume of the intercom can be adjusted using this
control.
g g SHUTTER switch g g
OFF: Electronic shutter does not function.
ON: Electronic shutter is activated.
1VF connector
SEL: The shutter speed and shutter mode change
each time the switch is set to this position.
2Cable clamp
h h h h VTR START button
When a Camera Control Unit (CCU) is connected, the
audio signal of the intercom is sent to the CCU while
3Lens mount lever
this button is held pressed. When a VTR is connected
using the CCZ cable of the CA-570/570P, pressing this
button starts recording, and pressing it again stops
recording. It is the same function as with the VTR
button on the lens.
i LENS connector (12-pin) i i i
Connect a lens cable.
4AUTO W/B BAL switch
j MIC (microphone) connector (3-pin) j j j
5MENU SELECT knob
Connect a microphone cable. Normally, connect the
microphone supplied with the BVF-10/ 10CE/ 20W/
20WCE Viewfinder. Phantom powering is turned off
6MIC LEVEL control
with the appropriate internal switch setting.