Status Menu; Device Info (Device Information Of The Camera And Setting Status Of Switches On The Back Of The Camera) - Sony SRG-X40UH Operating Instructions Manual

VIDEO FORMAT
Select the video format of the signal to be output
from the HDMI OUT and VIDEO OUT terminals.
The video format can be changed from this menu
when the SYSTEM SELECT switch is set to 6.
When the SYSTEM SELECT switch is set to a value
other than 6, the setting status of the SYSTEM
SELECT switch is displayed.
After the setting is changed, turn off the camera
and turn it on again, put the camera in the
standby mode and turn it on again, or execute
[REBOOT] to reflect the changes.
Select [2160/29.97p] (SRG-X40UH only),
[2160/25p] (SRG-X40UH only), [1080/59.94p],
[1080/50p], [1080/29.97p], [1080/25p],
[1080/59.94i], [1080/50i], [720/59.94p],
[720/50p], [480/59.94p] or [576/50p].
Note
The video format cannot be changed when the
SYSTEM SELECT switch is set to a value other than
6.
NETWORK
Enable or disable the network connection.
[ON]: Network connection is available.
[OFF]: Network connection is not available.
CONTROL
Set the operating command protocol.
[USB]: USB (UVC) control
[VISCA]: VISCA control
[VOIP]: VISCA over IP control
Note
When a command protocol is selected, the other
command protocols are not available.
VISCA RATE
Set the Baud Rate for RS-422 for VISCA control.
[9600]: 9600 bps
[38400]: 38400 bps
USB PRIVACY MODE
Set the panning for when Preview Off is set on
the TV conference software on the computer
connected via the USB cable.
[ON]: Moves the panning to the end position
automatically.
[OFF]: Does not move the panning
automatically.
REBOOT
Reboot the camera.

STATUS Menu

The STATUS menu is used to display the settings
selected with the menus. This menu only
displays the current menu settings, and you
cannot change them with this menu.
The current menu settings will vary depending
on the camera model. Press the  or  button of
the remote commander to switch PAGE.
PAGE1: Items in the EXPOSURE menu
PAGE2: Items in the COLOR menu
PAGE3: Items in the DETAIL menu
PAGE4: Items in the VISIBILITY ENHANCER menu
PAGE5: Items in the ZOOM/FOCUS menu
PAGE6: Items in the PICTURE menu
PAGE7: Items in the OPTICAL FILTER menu
PAGE8: Items in the PAN TILT menu
PAGE9: Items in the PRESET RECALL menu
PAGE10: Items in the VIDEO OUT menu
PAGE11: Items in the SYSTEM menu
PAGE12: Device information of the camera and
status of switch settings on the back of the
camera
PAGE13: Network settings
DEVICE INFO (Device information
of the camera and setting status of
switches on the back of the
camera)
Displays the device information.
MODEL NAME
Displays the model name of the camera.
SERIAL NUMBER
Displays the serial number of the camera.
VERSION
Displays the software version of the camera.
NAME
Displays the name applied to the camera.
Change this using the RM IP Setup Tool.
38