SANY SY265C LC Operation And Maintenance Manual page 193

SY265C LC/SY265C LR Excavator OMM
10. The engine oil filter (6) is behind the right rear door.
11. Place a catch container under the engine oil filter.
12. Remove the oil filter.
13. Inspect the drained oil and the filter for metal particles
and foreign material.
14. Clean the engine oil filter mating surface.
15. Apply a thin film of clean engine oil to the new filter
gasket.
16. Install the new engine oil filter until the filter gasket
makes contact with the filter mating surface, then
tighten the filter 3/4 turn more.
17. Remove either of the engine oil filler caps (7) and add
engine oil. See "Capacities" on page 5-14.
NOTICE!
Do not overfill the engine with oil. Overfilling
could result in machine damage and improper
machine operation.
18. Install the engine oil filler cap.
19. Remove the engine oil dipstick (8) from the engine,
wipe it with a clean cloth, then insert the dipstick in its
holder.
20. Remove the dipstick, note the oil level. Install the
dipstick.
NOTE: The oil level should be within the etched area
(9). If the oil is not within the etched area,
remove the engine oil filler cap, then add oil
until the level is within the etched area.
21. Start and run the engine at low idle for several minutes,
shut off the engine, and check for oil leaks.
22. Check the oil level. Add oil as needed.
SANY
Fig. 5-36
Fig. 5-37
Fig. 5-38
Operation and Maintenance Manual — 0420
6
7
8
9
0005320
0005314
5-39