Before Getting Started - Flo CoRe+ MAX Installation Manual

Pedestal and cable management system

Hide thumbs Also See for CoRe+ MAX:

Table of Contents

6.3.2.

Before Getting Started

Follow the steps below before getting started:

CAUTION: Before getting started, cut off the current to prevent an electric shock.

Make sure to remove the security screw used to hold the counterweight during transport when

unpacking the cable management system.

2. Install a cable management system on a new station OR install a cable management system on an existing

station by following the steps below:

6.3.2.1.

Before Installing a Cable Management System on a New Back-

to-Back Charging Station

First, install the pedestal and charging station. Refer to the

section 5

section(

. ) of this guide for more information and the

2. Then, prepare the installation material for the cable management systems and follow the instructions in

Installing the Back-to-Back Cable Management System

the

6.3.2.2.

Before Installing a Cable Management System on an Existing

Back-to-Back Charging Station

Prepare the installation material for the back-to-back charging station mount brackets and cable

management systems and follow the instructions below.

Installing the Pedestal and Charging Station

CoRe+ MAX Installation Guide

section below.

as needed.

Table of Contents

Do you have a question about the CoRe+ MAX and is the answer not in the manual?