Flo CoRe+ MAX Installation Manual page 23

Pedestal and cable management system
Hide thumbs Also See for CoRe+ MAX:
Table of Contents

Advertisement

6.1.2.1.
Before Installing a Cable Management System on a New Wall-
Mounted Charging Station
1.
First, install the charging station. Refer to the
section 5.
(
) above and the
management system as indicated in the Installing a
OR
6.1.2.2.
Before Installing a Cable Management System on an Existing
Wall-Mounted Charging Station
1.
Install the cable management system as indicated in the
section below.
2. Determine where the wall mount (column) will be placed. Leave 12'' to 14'' (30.48 cm to 35.56 cm)
between the column and the charging station. See the product measurements in the section below.
3. Determine the required wall attachment hardware (wall anchors, screws, and washers) to securely
attach the mount brackets to the wall. Use ¼'' diameter screws and anchors of the appropriate size if
the screws cannot be secured directly to a wall stud.
RECOMMENDATION: Install the column at least 6'' (15.24 cm) from the ground to allow enough clearance to
facilitate floor cleaning. The upper wall mount bracket should be installed at least 60'' (152.4 cm) above the
lower wall mount bracket.
Installing the Pedestal and Charging Station
CoRe+ MAX Installation Guide
Cable Management System
, as needed. Then, install the cable
section below.
Installing a Cable Management System
section
23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CoRe+ MAX and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents