Light Intensity Vs Distance; The Sense As Usb Module - NeuLog Sense Autonomous Manual

If the light readout is very low, try changing the sensor's mode to a higher
sensitivity. This is done by selecting the "Module setup" button on the light sensor
module box in the NeuLog application.
The Neulog light sensor is able to adjust to 3 different sensitivity settings for
ambient light because of its ability to change the internal hardware amplifier gain
through the application.
Changing from illumination mode into signal mode is done automatically by the
firmware according to the sampling rate.
2.5.2

Light intensity vs distance

In this experiment, we shall move the light sensor against a flashlight and a wall.
We shall measure the light intensity and the distance with a distance sensor.
The RobocklySense has instructions to run an experiment and to stop it.
The NeuLog sensors are logger sensors. They sample and save the measurements
in their flash memory.
2.5.3

The SENSE as USB module

The SENSE can act as a USB module for the Neulog application software.
With this software we can view graphically the experiment results after running
the RobocklySense program.
We can, of course, save and use all Neulog software functions.
78