Table of Contents
Advertisement
Procedure:
1.
Plug the NUL-213 motion sensor into one of the SENSE socket with its
transducer directly to the front of the SENSE.
2.
Connect the SENSE to the PC using the USB cable.
3.
Run the RobocklySense software.
4.
Move to Block
Create a program that moves the SENSE forward to a wall and stops 30 cm
away from it.
5.
Build the following program and its main procedure:
6.
Observe the program and make sure that you understand all of its
instructions.
7.
Place the SENSE in front of a wall and run the program.
The SENSE should move to the wall and stop 30cm away from it.
65
mode.
Advertisement
Table of Contents
