Table of Contents
Advertisement
Procedure:
1.
Connect the SENSE to the PC using the USB cable.
2.
Run the RobocklySense software.
3.
Test the SENSE motors as described in experiment 1.1.
4.
Test the SENSE Bottom sensor as described in experiment 1.1.
5.
Record the values of the Bottom sensor when the SENSE is on a white
surface. We shall call this value White Value.
6.
Record the values of the Bottom sensor when the SENSE is on the black line.
We shall call this value Black Value.
7.
Move to Block
26
mode.
Advertisement
Table of Contents
