Maintenance; Legal Information - Otto Bock Michelangelo Hand 8E500 Instructions For Use Manual

Hide thumbs Also See for Michelangelo Hand 8E500:
Table of Contents

Advertisement

CAUTION
Storage of the product in the closed state
Injury due to faulty control or malfunction of the product as a result of damage to the sensors
and mechanism.
Store the product only in the neutral position or in the open state.
INFORMATION
The Axon-Bus prosthetic system cannot be used as long as the charging plug is connected to
the charging receptacle. The Axon-Bus prosthetic system is deactivated for the duration of char­
ging.
7.3 Opening the Axon-Bus gripping component in an emergency

8 Maintenance

Performing regular maintenance (service inspections) every 24 months is recommended to pre­
vent injuries and maintain the quality of the product.
In general, all products are subject to compliance with the maintenance intervals during the war­
ranty period. This is the only way to maintain full warranty cover.
Additional services such as repairs may be provided in the course of maintenance. These addi­
tional services may be provided free of charge or can be billable according to an advance cost
estimate, depending on the extent and validity of the warranty.
The following components must always be sent in for maintenance and repairs:
The product, battery charger and power supply. The shipping container for the loaner unit you
receive must be reused for sending back the components requiring inspection.

9 Legal information

9.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
► 1) Push and hold the charging receptacle button until a confirma­
tion sound is heard (at least 1 second).
→ The prosthesis and prosthetic components are switched on.
Repeat this process to switch the prosthesis and prosthetic compo­
nents off.
This safety function allows the Axon-Bus gripping component to be
opened regardless of the control signals present.
1) With the Axon-Bus prosthetic system switched on, press the char­
ging receptacle button and hold for approximately three seconds
until the Axon-Bus gripping component begins to open.
→ A pulsating beep sounds as it opens.
2) Releasing the button immediately stops the process of opening
the Axon-Bus gripping component and turns the entire Axon-Bus
prosthetic system off.
11

Advertisement

Table of Contents
loading

Table of Contents