Information On Re-Use - Otto Bock C1000 SF Instructions For Use Manual

Legal information

9.2 Information on re-use

CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
► Replace the seat padding if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea­
tures and performance must not change in a way that could impair the safety of users or third parties during the
period of use.
The relevant product must be thoroughly cleaned and disinfected before re-use. Then have the product inspected
by qualified personnel with respect to its condition, wear and tear, and damage. Worn and damaged parts as well
as components that do not fit or are unsuitable for the user must be replaced.
Detailed information on replacing components as well as information on the required tools can be found in the ser­
vice manual.
10 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
10.2 Warranty
Further information on the warranty terms and conditions is available from the manufacturer's service (see inside
back cover for addresses).
10.3 Service life
Expected lifetime: 5 years
The design, manufacturing and requirements for the intended use of the product are based on the expected life­
time. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.
11 Technical data
INFORMATION
► Much of the technical data below is given in mm. Please note that product settings – unless otherwise spe­
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
General information
Application class (in compliance with DIN
EN 12184)
Dimensions and weights
Seat width
Seat depth
Seat height
Lower leg length
Angle of the seat surface
Angle of leg to seat
Distance from arm support to seat
Front position of the arm supports
Arm support height
Arm support length
18
Class B
430/480 mm
370–530 mm
530–630 mm (incl. seat cushion)
390–520 mm
0°–6°
90°–170°
225–325 mm
300–580 mm
160–260 mm
370 mm
C1000 SF