Adjusting The Belt Length; Adjusting The Control Device; Wheelchair Control Options; Attendant Control - Otto Bock C2000 Instructions For Use Manual

4

6.3.1.3 Adjusting the belt length

CAUTION
Incorrect approach to the adjustment process
Injuries, malpositions, user discomfort due to adjustment errors
► The qualified personnel is responsible for the individual positioning and fitting of the belt system.
► Adjusting the belt system too tightly may lead to unnecessary pain or user discomfort.
► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the
fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).
CAUTION
Lack of instruction
Injuries, malpositions, illness of the user due to incorrect information
► The qualified personnel is responsible for making sure that the user and/or attendant/nursing staff has under­
stood the proper adjustment, use, maintenance and care of the belt system.
► In particular, ensure that the user and/or attendant/care staff knows how to quickly loosen and open the
product to avoid delays in case of emergency.
Notes on correctly applying and adjusting the lap belt: see Page 44.

6.3.1.4 Adjusting the control device

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming the control device may only be performed by qualified personnel. The manufacturer of the
product and the control device manufacturer are not liable in case of damage caused by programming which
was not performed properly and/or which was not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configuration can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause an accident.
► After configuration/programming is complete, the user must test the driving characteristics of the product
under the supervision of the qualified personnel.

6.3.1.4.1 Wheelchair control options

If necessary, the programming of the wheelchair control unit can be adjusted to the specific user requirements.
Information on using the wheelchair control unit: see Page 23.
Troubleshooting information: see Page 65.
Further information on programming can be found in the 647G484=* service manual.

6.3.1.4.2 Attendant control

The power wheelchair can be ordered and equipped with an attendant control. It may be necessary to fit the
already installed attendant control to the actual body size of the attendant.
Information on operating the attendant control: see Page .
Troubleshooting information: see Page 66.
C2000
Fine-tuning the backrest
1) Open the side of the back pad. In order to do so,
loosen the hook-and-loop closures of the side open­
ings.
2) Select the correction pads as required. These can
be positioned by turning/sliding to offer additional
lateral guidance for the user.
3) Insert the correction pads as required.
4) Fasten the hook-and-loop closures on the side
openings again.
Preparing the product for use
17