WBM XPC500 Grapple Parts, Service And Installation page 19

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
OEM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
14. Fully weld the stop plate assembly to the side plates.
1/2
15. Slowly cycle the tool cylinder and check for functionality (smooth motion,
clearances, etc.).
16. Inspect the stop before every shift, to ensure it is not damaged or bent. Repair as
required.
The stop must be inspected and maintained daily. Do not operate the grapple if the stop is
damaged or missing. Failure to comply could result in property damage.
* SUGGESTED WELD PROCEDURES ONLY. Warranty of stick is not covered by WELDCO-
BEALES MFG. LTD. due to installation of cylinder anchor and grapple. If further
information on weld specifications and warranties are required, contact the machine
manufacturer.
Weldco-Beales Manufacturing
NOTICE
Attachment may not be exactly as illustrated
WBM
Page 19