WBM XPC500 Grapple Parts, Service And Installation page 11

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
WBM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
4. Measure the thickness of the stop assembly top plate (D1).
5. Raise the grapple so the tines are just touching the ground.
6. Maneuver the grapple such that the stops would be just touching the underside
of the arm. DO NOT touch the side plates to the underside of the arm. DO leave
enough space for the stop plate assembly. (Position such that the distance from the
grapple side plates to the underside of the arm (D2) equals the thickness of the stop
assembly top plate (D1).
Use extreme care while maneuvering and measuring the grapple. Ensure there is no chance of
the grapple swinging or becoming unstable. Grapples with offset lugging are especially likely to
swing (due to offset center of gravity). Failure to comply could result in property damage, serious
injury or death.
STOP PLATE ASSEMBLY
Weldco-Beales Manufacturing
STOP PLATE ASSEMBLY
! WARNING
D1
Attachment may not be exactly as illustrated
D1
D2
WBM
Page 11