WBM XPC500 Grapple Parts, Service And Installation page 13

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
WBM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
9. Trim the side plates.
10. Once the side plates are trimmed, move the grapple into a safe position to tack
weld the stop assembly.
11. Tack weld the stop assembly.
12. Maneuver the grapple back into the 'stopped' position. (Raise the grapple so the
tines are touching the ground. Maneuver the grapple so the stops are contacting
the underside of the stick.) Do not slam the attachment against the underside of the
arm.
13. If the stops are not squarely contacting the underside of the stick; trim or reposition
as required. Once stops are correctly located, move to next step.
14. Check that the cylinder anchor is flat on the stick. Fully extend the tilt cylinder, then
retract the cylinder 3/8" to 1/2".
ANCHOR FLAT
ON STICK
Weldco-Beales Manufacturing
Attachment may not be exactly as illustrated
WBM
Page 13