WBM XPC500 Grapple Parts, Service And Installation page 15

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
WBM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
18. Fully weld the stop plate assembly to the side plates.
1/2
19. Slowly cycle the tool cylinder and check for functionality (smooth motion,
clearances, etc.).
20. Fully weld the cylinder anchor to the stick. Remove any notches/imperfections in
weld by using pigtail run out welds and grinding the weld smooth.
DO NOT WELD
ACROSS ENDS
E7018 OR
EQUIVALENT
3/8
21. Inspect the stop before every shift (to ensure it is not damaged or bent). Repair as
required.
The stop must be inspected and maintained daily. Do not operate the grapple if the stop is
damaged or missing. Failure to comply could result in property damage.
* SUGGESTED WELD PROCEDURES ONLY. Warranty of stick is not covered by WELDCO-
BEALES MFG. LTD. due to installation of cylinder anchor and grapple. If further
information on weld specifications and warranties are required, contact the machine
manufacturer.
Weldco-Beales Manufacturing
CYLINDER
ANCHOR
NOTICE
Attachment may not be exactly as illustrated
WBM
SMOOTH
WELD EDGE
TOP VIEW
SIDE VIEW
Page 15