XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
WBM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
WBM Supplied Tool Cylinder and Cylinder Anchor
If using a WBM supplied tool cylinder and cylinder anchor, follow this procedure.
If using an OEM supplied tool cylinder and cylinder anchor, follow OEM instructions
and the procedure starting on the page titled OEM Supplied Tool Cylinder and
Cylinder Anchor.
1. Pin the cylinder anchor onto the barrel-end of the cylinder. Use the WBM pin and
mounting hardware. Shim to minimize side to side movement.
CYLINDER
ANCHOR
2. Pin cylinder rod end to the grapple turret, use supplied pin and mounting hardware.
3. Connect hydraulic hoses to the tool cylinder, as per hydraulic schematic. For
hydraulic schematic and torque specifications, see parts pages. The cylinder
will need to be extended and retracted (later in the instructions), to position the
cylinder anchor.
Weldco-Beales Manufacturing
PIN
Attachment may not be exactly as illustrated
WBM
Page 10