XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
OEM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
OEM Supplied Tool Cylinder and Cylinder Anchor
If using an OEM supplied tool cylinder and cylinder anchor: follow this procedure. If
using a WBM supplied tool cylinder and cylinder anchor: follow the procedure starting
on the page titled WBM Supplied Tool Cylinder and Cylinder Anchor
1. Pin cylinder rod end to the grapple turret, use supplied pin and mounting hardware.
WBM supplied anchor is shown.
2. Connect hydraulic hoses to the tool cylinder, as per OEM instructions.
3. Fully extend the tilt cylinder, then retract the cylinder 3/8" to 1/2" (if OEM cylinder
recommendations are not available).
ANCHOR FLAT
ON STICK
Weldco-Beales Manufacturing
Attachment may not be exactly as illustrated
WBM
Page 16