WBM XPC500 Grapple Parts, Service And Installation page 17

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
OEM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
4. Position the grapple in a safe and secure position. Always follow all safe operating
procedures.
5. Always follow safe operating procedures. Use a ladder or rolling stairs to measure
the distances: A1, A2, B1 and B2 (on the turret) and the thickness of the stop plate
assembly's top plate (D1), as shown in the following illustration.
STICK/ ARM
8. Compare these measurements and prepare to trim/ build-up the side plates. Keep
in mind the final location of the stop plate assembly and the required jaw and hose
clearances.
FINAL
LOCATION OF
STOP PLATE
ASSEMBLY
Weldco-Beales Manufacturing
A2
A1
B2
B1
Attachment may not be exactly as illustrated
EDGE TO BE
TRIMMED OR
BUILT UP
WBM
D1
STOP PLATE ASSEMBLY
PROFILE OF
SIDE PLATE
Page 17