WBM XPC500 Grapple Parts, Service And Installation page 12

XPC500 / XPC600 GRAPPLE
PARTS, SERVICE AND INSTALLATION
INSTALLATION
WBM SUPPLIED TOOL CYLINDER AND CYLINDER ANCHOR INSTALLATION
7. Always follow all safe operating procedures. Use a ladder or rolling stairs to measure
the distances: A1, A2, B1 and B2 (as shown in the following illustration).
STICK/ ARM
8. Compare these measurements to the thickness (D1) of the stop assembly's top
plate. Prepare to trim the side plates. Keep in mind the final location of the stop
plate assembly and the required jaw and hose clearances.
FINAL
LOCATION OF
STOP PLATE
ASSEMBLY
Weldco-Beales Manufacturing
A2
A1
B2
B1
Attachment may not be exactly as illustrated
EDGE TO BE
TRIMMED
WBM
D1
STOP PLATE ASSEMBLY
PROFILE OF
SIDE PLATE
Page 12