D Quiet Mode "Quiet; D Lockout "Lock-O; D Roger Beep "Rgr-B; D Battery Voltage "Batt - Icom IC-410PRO Advanced Manual

3
SET MODE
Set mode items (Continued)

D Quiet mode "QUIET"

Turn On or OFF the Quiet mode for Selcall. See page
7-4 for details.
Quiet mode OFF (default)

D Lockout "LOCK-O"

Select the transmission Lockout function mode which
temporarily inhibits transmission.
• RP (Repeater Lockout): Locks out a repeater.
• BU (Busy Lockout):
• OF (OFF):
Lockout OFF (default)

D Roger beep "RGR-B"

You can turn ON the Roger Beep function to beep to
indicate that the transmission has ended.
Roger Beep OFF (default)

D Battery Voltage "BATT"

You can set to display the Battery Voltage for 2
seconds, when you turn ON the transceiver.
Battery Voltage display
OFF (default)

D Auto Power OFF "AP-OFF"

You can set the transceiver to automatically turn OFF
after the set period without any key operation. You can
set it to between 0.5 and 4.0 hours (0.5 hour steps) or
8.0 hours.
Auto Power OFF
is OFF (default)
Quiet mode ON
Locks out a busy channel.
Turns OFF the function.
Busy lockout
Roger Beep ON
Battery Voltage display ON
2 hour setting

D Signal Monitor "SMON"

You can select whether or not to sound a beep when
you transmit a Selcall code or DTMF code signal.
ON: A beep sounds.
OFF: No beep sounds.
Signal Monitor ON (default)

D Horn "HORN"

Select whether or not to activate the HORN terminal
when a call is received. This function is useful when a
user is away from the transceiver.
*An external horn and an optional OPC-1939
required. Ask your dealer for details.
Horn is OFF (default)

D RX VFO "RX VFO"

Edit the RX channel frequency. See page 8-3 for
details.

D Scan Stop Timer "S-TIME"

You can set the Scan Stop Timer to pause (P5) or
timer scan (5/10/15). When a signal disappears, the
scan resumes after the set period of time.
5/10/15: Scan pauses for 5, 10 or 15 seconds when a
signal is detected, then resumes.
P5: Scan pauses until the signal disappears,
and then resumes after 5 seconds
(Recommended setting).
Scan Stop Timer
P5 (default)

D Scan Restart "SCAN-R"

This function restarts the scan 10 seconds after you
stop transmitting. You can turn the function ON or
OFF.
Scan Restart OFF (default)
3-4
Signal Monitor OFF
is
acc cable
Horn is ON
10 second setting
Scan Restart ON