Cisco RJ-45-to-AUX Brochure page 372

1912EN(config)# enable password level ?
<1−15> Level number
1912EN(config)# enable password level 1 coriolis1
1912EN(config)# enable password level 15 coriolis2
1912EN (config)# enable secret coriolispass
5. Enter Interface Configuration mode to configure the Fast Ethernet 0/27 port on the 1912EN. Enter the
switch's IP address and the default gateway (router):
(config)# interface f0/27
(config−if)#ip address 63.78.39.164 255.255.255.0
(config)#
1912EN(config)#ip default−gateway 63.78.39.254
1912EN(config)#
6. Enable trunking on this port to always be on:
1912EN(config−if)#trunk ?
auto Set DISL state to AUTO
desirable Set DISL state to DESIRABLE
nonegotiate Set DISL state to NONEGOTIATE
off Set DISL state to OFF
on Set DISL state to ON
1912EN(config−if)#trunk on
1912EN(config−if)# exit
1912EN (config)#
7. Assign VLAN names:
1912EN(config)#vlan 2 name CAD
1912EN(config)#vlan 3 name Graphics
1912EN(config)#vlan 4 name DocProduction
8. Assign the VLAN number that matches the Ethernet port number on the front of the switch:
1912EN#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
1912EN(config)#interface e0/2
1912EN(config−if)#vlan−membership static ?
<1−1005> ISL VLAN index
1912EN(config−if)#vlan−membership static 2
1912EN(confi−if)# exit
1912EN(config)#interface e0/3
1912EN(config−if)#vlan−membership static 3
1912EN(confi−if)# exit
1912EN(config)#interface e0/4
1912EN(config−if)#vlan−membership static 4
1912EN(config−if)#exit
9. Enable this device to be a VTP server for the Coriolis VTP domain:
1912EN(config)#vtp ?
client VTP client
domain Set VTP domain name
password Set VTP password
pruning VTP pruning
server VTP server
transparent VTP transparent
trap VTP trap
1912EN(config)#vtp domain ?
WORD Name of the VTP management domain
356