Configuring The Mpc; Configuring The Mps; Changing The Mps Variables - Cisco RJ-45-to-AUX Brochure

——— ———————— ————————— —————————— ——————
2 EARL 1+ WS−F5511
Mod SMT User−Data
——— ——————————————————— ———————— ——————
5 WorkGroup Stack
CoriolisLS1010>

Configuring the MPC

This example configures the MPC and binds an LEC to the MPC:
1. Define the MPC with the name THEMPC, as follows:
mpoa client config name THEMPC
2. Specify the ATM interface to which the MPC is attached. In this example, the interface is 1/2:
interface ATM 1/2
3. Associate the interface to the MPC named MYMPC as follows:
mpoa client name MYMPC
4. Enter Subinterface Configuration mode for the ATM interface that contains the LEC to which you
will bind the MPC:
interface atm 1/2.1
5. To bind a LANE client to the specified MPC, use this command:
lane client mpoa client name MYMPC

Configuring the MPS

The following example shows the proper configuration of the MPS and attaches the MPS to a hardware
interface:
1. Define the MPS named THEMPS:
mpoa server config name THEMPS
2. Enter Interface Configuration mode for the ATM interface:
interface ATM 1/1
3. Attach the MPS called THEMPS to a hardware interface:
mpoa server name THEMPS

Changing the MPS Variables

MPS variables affect only a particular MPS. Perform the following tasks starting in MPS Configuration mode:
0002278010 1.0
T−Notify CF−St
30 isolated in
ECM−St Bypass
——————— ——————
absent
193