Cisco RJ-45-to-AUX Brochure page 321

[P] VTP Statistics
2. Select [V], and accept the default setting of Server. Because the change we want to make is to add a
server, we will take the defaults:
VTP mode may be set to [C]lient, [S]erver or [T]ransparent:
Current setting ===> Server
New setting ===> Server
3. Select [A] to add an Ethernet VLAN to the switch. You'll see the following:
The following VLAN types can be added:
[1]Ethernet, [2]FDDI, [3]Token−Ring, [4]FDDI−Net, or [5]Token−Ring−Net
Select a VLAN type [1−5]: 1
4. Now we need to specify a name for the newly created VLAN. To change the name to "Techs" we
need to select option [V], as shown in the following output:
Enter Selection: V
This command selects the unique name of a VLAN.
Configuration change only takes effect when the VLAN SAVE command is
executed.
A string of up to 32 characters may be specified to name a VLAN.
Example: Engineering, Manufacturing, Blue
Enter VLAN name (32 characters max):
Current setting ===> VLAN0002
New setting ===> Techs
5. Now you need to save the VLAN configuration. To do so, select option [S]. Save and exit.
6. To view information about your newly created VLAN, from the Virtual LAN Configuration menu,
choose [M].
7. Next, select the VLAN you want information on. In this case, it's VLAN 2. Enter "2" and you should
see the following:
Catalyst 1900 − Modify Ethernet VLAN
—————————————————————— Information ————————————————————————————————————————
Current member ports:
Type: Ethernet
VLAN Number: 2
—————————————————————— Settings ———————————————————————————————————————————
[V] VLAN Name
[I] 802.10 SAID
[M] MTU Size
[L] Translational Bridge 1
[J] Translational Bridge 2
[T] VLAN State
—————————————————————— Related Menus ———————————————————————————————————————————
[S] Save and Exit
[N] Cancel and goto Next VLAN
[P] Cancel and goto Previous VLAN
8. To exit from this screen, select option [X].
9. To configure your trunk ports (Ax and/or Bx) to pass the VLAN information to neighboring switches,
you must enable at least one of the trunk ports. From the Virtual LAN Configuration menu select
option [T].
10. Now you need to enter a trunk port. We will be configuring port A:
Select a trunk port [A, B] : A
[X] Exit to Main Menu
Techs
100002
1500
0
0
Enabled
[X] Cancel and Exit
[G] Cancel and goto VLAN
305