Verifying A Lec Configuration On An Elan - Cisco RJ-45-to-AUX Brochure

ATM(config)#interface atm0.1
3. Map the LEC bus to the Ethernet ELAN named "default":
ATM(config−subif)#lane client ethernet default
4. Repeat Steps 2 and 3 for each LEC you want to configure on this LANE module.
5. Enter Interface Configuration mode for the ATM0 subinterface 2:
ATM(config−subif)#interface atm0.2
6. Map the LEC bus to the Ethernet ELAN named ELAN2:
ATM(config−subif)#lane client ethernet ELAN2
ATM(config−subif)#end

Verifying a LEC Configuration on an ELAN

To verify the previous operation, issue the following command:
ATM#show lane client
LE Client ATM0.1 ELAN name: default Admin: up State: initialState
Client ID: unassigned
Join Attempt: 4
Last Fail Reason: Config VC being released
HW Address: 0010.0daa.cc40
VLANID: 1
ATM Address: 47.00918100000000E04FACB401.00100DAACC40.01
VCD rxFrames txFrames Type
0 0
47.007900000000000000000000.00A03E000001.00
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
LE Client ATM0.2 ELAN name: TEST_ELAN Admin: up State: initialState
Client ID: unassigned
Join Attempt: 2
Last Fail Reason: Config VC being released
HW Address: 0010.0daa.cc40
VLANID: 2
ATM Address: 47.00918100000000E04FACB401.00100DAACC40.02
VCD rxFrames txFrames Type
0 0
47.007900000000000000000000.00A03E000001.00
VCD rxFrames txFrames Type
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
0 0
00.000000000000000000000000.000000000000.00
In the previous example, the state is initialState. This state indicates that the LEC is not yet a member of the
ELAN. The zeroes in the ATM address columns are an indication that the LECS database has not yet been
configured. This is normal—LECS will not come up until the LES/BUS is configured and the LECS database
has been configured.
Next join attempt in 0 seconds
Type: ethernet
ATM Address
0 configure
0 direct
0 distribute
0 send
0 forward
Next join attempt in 1 seconds
Type: ethernet
ATM Address
0 configure
ATM Address
0 direct
0 distribute
0 send
0 forward
Max Frame Size: 1516
Max Frame Size: 1516
180