Using The Port Configuration On A Set/Clear Command−Based Ios; Using The Show Port Command On A Cli−Based Ios - Cisco RJ-45-to-AUX Brochure

Using the Port Configuration on a Set/Clear Command−Based
IOS
The show port command can be used on a Set/Clear command−based IOS switch to view the port
configuration. Let's take a look at the command, its optional syntaxes, and an example of its output:
show port [module/port]
show port [module]
Catalyst5002> (enable) show port 2/1
Port Name Status
———— ———————— ———————— ———— —————— —————— —————— ——————
2/1 Port1 normal
Port Security Secure−Src−Addr
———— ———————— ——————————————— —————————————— ———————— ————————
2/1 enabled 0090.80a3.32a0
Port Broadcast−Limit Broadcast−Drop
———————— —————————————— ——————————————
2/1
Port Status Channel
Mode
———— —————————— ———————— —————————— —————————————— ————————
2/1 connected on
Port Align−Err FCS−Err
———— —————————— —————————— —————————— —————————— ————————
2/1 0
Port Single−Col Multi−Coll Late−Coll
———— —————————— —————————— —————————— —————————— ————————
2/1 3442
Using the show port Command on a CLI−Based IOS
The show port command can be used on a CLI−based IOS switch to view the port configuration. Let's take a
look at the command, its syntaxes, and an example of its output:
1912EN#show port ?
block Forwarding of unknown unicast/multicast addresses
monitor Port monitoring
system System port configuration
1912EN#show port block ?
multicast Forwarding of unregisterd multicast addresses
unicast Forwarding of unknown unicast addresses
1912EN#show port block multicast
Ports receiving unregistered multicast addresses:
Ethernet 0/1, Ethernet 0/2, Ethernet 0/3, Ethernet 0/4
Ethernet 0/5, Ethernet 0/6, Ethernet 0/7, Ethernet 0/8
Ethernet 0/9, Ethernet 0/10, Ethernet 0/11, Ethernet 0/12
Ethernet 0/25, FastEthernet 0/26, FastEthernet 0/27
1912EN#show port block unicast
Ports receiving unmatched unicast addresses:
Ethernet 0/1, Ethernet 0/2, Ethernet 0/3, Ethernet 0/4
Ethernet 0/5, Ethernet 0/6, Ethernet 0/7, Ethernet 0/8
Vlan Level Duplex Speed
2 full
Last−Src−Addr
0090.80a3.32a0 No
− 0
Channel Neighbor
status device
not channel
Xmit−Err Rcv−Err
0 6
Excess−Col Carri−Sen Runts
603 0
Type
100 100BaseT
Shutdown Trap
−
Neighbor
port
UnderSize
0 0
————————
0 0
333
Giants
——————
1 0