Testing External Module Hardware On A Set/Clear Command−Based Switch; Viewing The System Configuration On A Set/Clear Command−Based Switch - Cisco RJ-45-to-AUX Brochure

——————————————
. . .
Channel Status :
Ports 1 2
——————————————
. .
Note There is no comparable command on the 1900EN series switches.
Testing External Module Hardware on a Set/Clear
Command−Based Switch
The Catalyst 5002 I am using has a Supervisor Engine in Slot 1. Slot 2 has a 10/100 Ethernet Interface Card
with 24 ports. Let's look at the show test command, its optional syntax, and an example of a test on this
module:
show test [module number]
Catalyst5002> (enable) show test 2
Module 2 : 24−port 10/100 Ethernet
LCP Diag Status for Module 2
CPU : .
RAM : .
Saints : .
SAINT/SAGE Status :
Ports 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
————————————————————————————————————————————————————————————————————
Packet Buffer Status :
Ports 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
————————————————————————————————————————————————————————————————————
Loopback Status [Reported by Module 1] :
Ports 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
————————————————————————————————————————————————————————————————————
Note There is no comparable command on the 1900EN series switches.
Viewing the System Configuration on a Set/Clear
Command−Based Switch
To view the system configuration on a Set/Clear command−based IOS switch, use the show system
command. Let's take a look at the command and an example of its output:
Catalyst5002> (enable) show system
PS1Status PS2Status Fan−Status Temp−Alarm Sys−Status Uptime d,h:m:s Logout
———————— ———————— —————————— —————————— —————————— —————————————— ——————
ok off
PS1−Type PS2−Type
—————————— —————————— —————— ———— —————— ———— —————————————————————————
WS−C5008B WS−C5008B
System Name System Location
———————————— ———————————————————————— ————————————————————
Catalyst5002 Sacramento, CA
Note There is no comparable command on the 1900EN series switches.
(. = Pass, F = Fail, N = N/A)
Sprom : . Bootcsum : .
LTL : . CBL
Pkt Bufs : . Repeater : N
ok off
Modem Baud Traffic Peak Peak−Time
disable 9600 0%
Archsum
: N DPRAM
FLASH
ok 93,3:21:60
0% Sat Sep 09 2000, 8:16:58
System Contact
Sean Odom
323
: .
: N SAMBA : .
: .
none