Removing The Multicast Router; Configuring Igmp Snooping; Disabling Igmp Snooping; Configuring Igmp Fast−Leave Processing - Cisco RJ-45-to-AUX Brochure

———— ————————
2/14 * 3
3/1 1
Total Number of Entries = 2
'*' − Configured
The asterisk between the port and the VLAN number means the multicast router port was manually
configured.

Removing the Multicast Router

Use the following command to remove the multicast router port:
Coriolis> (enable) clear multicast router 2/14
Port 2/14 cleared from multicast router port list.

Configuring IGMP Snooping

IGMP snooping is disabled by default. To enable IGMP snooping, use the following command:
Coriolis> (enable) set igmp enable
IGMP Snooping is enabled.
CGMP is disabled.
Note The switch will not let you enable IGMP snooping if CGMP or GMRP is enabled.

Disabling IGMP Snooping

To disable IGMP snooping, use the following command:
Coriolis> (enable) set igmp disable
IGMP feature for IP multicast disabled.
Configuring IGMP Fast−Leave Processing
To enable IGMP fast−leave processing, enter the following command:
Coriolis> (enable) set igmp fastleave enable
IGMP fastleave set to enabled.
CGMP is disabled.
Disabling IGMP Fast−Leave Processing
To disable IGMP fast−leaving processing, use the following command:
Coriolis> (enable) set igmp fastleave disable
IGMP fastleave set to disable.
152