Viewing The Software Version On A Set/Clear Command−Based Ios Module; Viewing The Ios Version Information On A Cli−Based Ios; Using The Show Flash Command On A Set/Clear Command−Based Ios - Cisco RJ-45-to-AUX Brochure

1912EN#
Viewing the Software Version on a Set/Clear Command−Based
IOS Module
To view the software version of a module on a Set/Clear command−based IOS, use the show version
command. This command will not work on internal route processor modules, however. Let's look at the
command and an example of its output:
show version <slot number>
Catalyst5002> (enable) show version 1
Mod Port Model
—— ———— ——————————
1 2 WS−X5530
Console> (enable)
Viewing the IOS Version Information on a CLI−Based IOS
To view the IOS version information on a CLI−based IOS, use the show version command. Let's take a look
at the command and its output:
1912EN#show version
Cisco Catalyst 1900/2820 Enterprise Edition Software
Version V8.01.02
Copyright (c) Cisco Systems, Inc. 1993−1998
1912EN uptime is 0day(s) 01hour(s) 33minute(s) 17second(s)
cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memory
Hardware board revision is 5
Upgrade Status: No upgrade currently in progress.
Config File Status: No configuration upload/download is in progress
15 Fixed Ethernet/IEEE 802.3 interface(s)
Base Ethernet Address: 00−30−80−54−6C−00
1912EN#
Using the show flash Command on a Set/Clear
Command−Based IOS
You can use the show flash command on a Set/Clear command−based IOS switch. You can view use optional
syntaxes to view the individal chip or file system information. Let's take a look at the command and its
output:
show flash [[m/]device:] [all|chips|filesys]
Catalyst5002> show flash
File Version
—————————————— ———————————— ———————————— —————— ————————————————
c5000 nmp 3.1(213−Eng) 02−11
Serial # Versions
——————————— ————————————————————
006851332 Hw : 1.3
Fw : 3.1.2
Fw1: 4.2(1)
Sw : 4.2(1)
Sector Size
1316809 06/16/00 00:26:21
321
Built