Using The Debug Command - Cisco RJ-45-to-AUX Brochure

Tip To get a brief output of all the configured interfaces, you can use the show standby brief
command.

Using the debug Command

By enabling the debug command, it will list the changes in real−time for the HSRP group you specified. This
includes the sending and receiving packets through the HSRP. To enable debugging of your HSRP group you
need to use the following command at the Privileged Exec prompt:
debug standby
Warning The debugging feature is automatically assigned a high priority on the CPU, so this command can
have a big impact on the internal route processor's performance.
To disable the debugging feature, enter either the no debug standby or the no debug command.
253