Monitoring And Viewing The Mls Configuration; Viewing The Mls Aging Configuration On A Catalyst 6000; Displaying The Ip Mls Configuration; Viewing Mls−Rps - Cisco RJ-45-to-AUX Brochure

Monitoring and Viewing the MLS Configuration

Commands on each MLS−SE and MLS−RP to monitor and view the configurations of each device are
different. Let's take a look at the following commands:

Viewing the MLS aging configuration on a Catalyst 6000

Displaying the IP MLS configuration

Viewing MLS−RPs
Viewing MLS−RP specifics
Displaying MLS VTP domain information
Viewing the MLS VLAN interface information
Viewing MLS statistics on the Catalyst 5000
Viewing MLS statistics on the Catalyst 6000
Viewing MLS entries
Viewing the MLS Aging Configuration on a Catalyst 6000
To see the MLS aging configuration on a Catalyst 6000, use the show mls aging command as shown here:
MLS−RP# show mls aging
enable timeout packet threshold
—————— ——————— —————— —————————
normal aging false
fast aging false
long aging false
Displaying the IP MLS Configuration
To display the MLS configuration for the MLS−RP, use the following command:
MLS−RP# show mls rp
The output should look similar to this:
ip multilayer switching is globally enabled
ipx multilayer switching is globally enabled
ipx mls inbound acl override is globally disabled
mls id is 0008.80e4.abd2
mls ip address 38.187.127.254
mls ip flow mask is destination
mls ipx flow mask is unknown
number of domains configured for mls 1
Viewing MLS−RPs
To see which MLS−RPs are configured on an MLS switch, use the following command:
MLS−RP> (enable) show mls include
Included MLS−RP
———————————————————
38.187.128.254
38.187.127.254
Console> (enable)
Viewing MLS−RP Specifics
To display MLS information for a specific MLS−RP on an MLS switch, enter the following:
MLS−RP> (enable) show mls rp 38.187.128.254
300 N/A
32 100
900 N/A
240