Configuring Port Monitoring On The Standard Edition Ios - Cisco RJ-45-to-AUX Brochure

10. We now want to bind the IP address of our SNMP management station to the trap community string.
To do this, enter the new community string, and select [1]. Then select [A] to enter the IP address.
The following will appear on your screen:
Enter Trap Manager community string (32 characters max):
Current setting ===>
New setting ===> Techtraps
Catalyst 1900 − Network Management (SNMP) TRAP Configuration
——————————————————————— Settings ——————————————————
[1] First TRAP community string
[A] First TRAP manager name or IP address
[2] Second TRAP community string
[B] Second TRAP manager name or IP address
[3] Third TRAP community string
[C] Third TRAP manager name or IP address
[4] Fourth TRAP community string
[D] Fourth TRAP manager name or IP address
[U] Authentication trap generation
[L] LinkUp/LinkDown trap generation
[X] Exit to previous menu
Enter Selection: A
SNMP Trap Manager is the management station to which the switch will
send any SNMP traps (alerts). The types of traps the switch can send
are authentication traps, linkUp/linkDown traps, among others. From the
Management Console, up to 4 Trap management stations can be defined.
If no trap managers are defined, the switch will not send any traps.
Enter First Trap Manager server name or IP address:
Current setting ===>
New setting ===> 63.78.39.84
11. Notice that that IP address is the previously configured SNMP management station. Once this has
been completed, you have successfully enabled SNMP on a Catalyst 1900 switch.
Related solution:
Enabling SNMP Contact

Configuring Port Monitoring on the Standard Edition IOS

To configure port monitoring, start from the Main Menu and do the following:
1. Select option [M] to begin to configure port monitoring.
2. To capture information you will need to add ports to monitor. In the following example, we will select
all ports and enable capturing:
Catalyst 1900 − Monitoring Configuration
——————————— Settings ——————————————————————————————————
[C] Capturing frames to the Monitor
[M] Monitor port assignment
Current capture list: No ports in list
Techtraps
Enabled
Enabled
Found on page:
58
Disabled
None
303