Viewing The Rsm's Running Configuration; Configuring Intervlan Routing On An Rsm - Cisco RJ-45-to-AUX Brochure

Note The commands for configuring the RSM, RSFC, and MSM are the same.

Viewing the RSM's Running Configuration

To view the RSM's running configuration, use the show running−config command as shown here:
Coriolis5000RSM# show running−config
Building configuration...
Current configuration:
!
version 11.2
no service udp−small−servers
no service tcp−small−servers
!
hostname Coriolis5000RSM
!
enable book1234
!
!
interface Vlan1
ip address 130.77.20.15 255.255.254.0
!
interface Vlan2
ip address 130.77.20.15 255.255.254.0
!
interface Vlan3
ip address 130.77.20.16 255.255.254.0
shutdown
!
router eigrp 100
network 130.77.0.0
no auto−summary
!
ip default−gateway 130.77.20.254
no ip classless
snmp−server community public RO
snmp−server community private RW
!
line con 0
line aux 0
line vty 0 4
password book1234
login
!
end
Coriolis5000RSM#
Warning In order to keep new changes when the switch is cycled, don't forget to save the
configuration to the NVRAM.

Configuring InterVLAN Routing on an RSM

Before you configure the RSM, you must configure the switch as a VTP server and assign a VTP domain
name. You must also configure the ISL trunk links and assign the switch ports on each switch to the
appropriate VLAN. To configure the RSM for interVLAN routing, use the following steps:
1. Start a session on the RSM for module 5:
Coriolis5002> (enable) session 5
Trying Router−5...
Connected to Router−5.
Escape character is Ô^]'.
2. Create one VLAN interface for each VLAN configured on the switch:
127