Appendix B: Basic Ios Cli−To−Set/Clear Commands; Overview - Cisco RJ-45-to-AUX Brochure

Appendix B: Basic IOS CLI−to−Set/Clear Commands

Overview

Many features are supported by the Set/Clear−based switches, which include the Catalyst 5000 and 6000
families of switches. Most basic commands on a Command Line Interface (CLI)−based IOS can be mapped to
commands that provide similar functionality on the Set/Clear−based CLI.
Table B.1 maps the 1900EN commands with those of the 5000 family of switches.
Table B.1: 1900EN commands mapped to 5000 commands.
1900EN IOS−Based Switch
description <description_string>
duplex
<auto|full|full−flow−control|half>
<mod|number>
enable password level 1 <password> Sets the switch
enable password level 15 <password> Sets the enable
hostname <name>
ip address <ip_address> <netmask>
N/A
N/A
no trunk−vlan <vlan_range>
no spantree <vlan−list>
port−channel mode
<on|off|auto|desirable>
show interface<type><mod|port>
show ip
show running−config
show spantree <vlan>
show uplink−fast
Description Set/Clear−Based Switch
Configures the set port name <modnumber>
port name <description>
Sets the port set port duplex
duplex <half|full>
set password
password
set enablepass
password
Sets the set prompt <name>
prompt/hostname
Sets the IP set interface sc0
address <ip_address><netmask>
Sets the port set port speed <mod/number>
speed <10|100|auto>
Sets the system set system name <name>
name
Clears a trunk clear trunk <mod/num>
port <vlan_range>
Disables set spantree disable <mod|number>
Spanning−Tree
Protocol (STP)
Sets the port set port channel <mod|number>
channel mode <on|off|auto|desirable>
Shows the port show port <mod/number>
configuration
Shows the show interface
configured IP
address
Shows the show config
running
configuration
Shows the show spantree <vlan>
spanning−tree
configuration
Shows the show spantree uplinkfast
UplinkFast
345