Configuring Vtp Pruning On A Catalyst 1900 Switch; Configuring Vtp On A Set/Clear Cli Switch; Configuring Vtp On A 1900 Cisco Ios Cli Switch - Cisco RJ-45-to-AUX Brochure

Configuring VTP Pruning on a Catalyst 1900 Switch

To configure the switch for VTP pruning, use the following command:
1912(config)# vtp pruning

Configuring VTP on a Set/Clear CLI Switch

Before you can configure a router or internal route processor for interVLAN routing, you must enable VTP,
assign a mode, and configure a domain.
1. You enable and configure VTP and VLANs on the switch in Privileged mode. To enable VTP and
specify a VTP mode, use the set vtp mode {client | server | transparent} command, as follows:
5002> (enable) set vtp mode server
VTP domain modified
2. If you set the mode to client or server, then you need to set the VTP domain name and password on
the first switch. The VTP name can be up to 32 characters long. The password is a minimum of 8
characters with a maximum of 64. For our example, we set the mode to server. The following shows
the available syntaxes for the set vtp domain option:
5002> (enable) set vtp domain ?
Usage: set vtp [domain <name>] [mode <mode>] [passwd <passwd>]
(mode = client|server|transparent
Use passwd Ô0' to clear vtp password)
Usage: set vtp pruneeligible <vlans>
(vlans = 2..1000
An example of vlans is 2−10,1000)
You must configure a VTP domain name if you choose to configure the switch as a VTP client or
server. To do so, use the set vtp domain name command, as follows:
5002> (enable) set vtp domain Coriolis
VTP domain Coriolis modified
3. Set the password to "pass1" for the VTP domain with the following command:
5002> (Enable) set vtp passwd pass1

Configuring VTP on a 1900 Cisco IOS CLI Switch

The 1900 switch does not require you to set the VTP password, just the domain name. The following shows
the options available for the vtp domain command:
1900EN(config)#vtp domain ?
WORD Name of the VTP management domain
1900EN(config)#vtp domain Coriolis ?
client VTP client
pruning VTP pruning
server VTP server
transparent VTP transparent
trap VTP trap
Here is an example of setting the domain to "Coriolis" on the 1912EN:
[pruning <enable|disable>] [v2 <enable|disable>
110