Final Assembly - Otto Bock E-MAG Active 17B203 Instructions For Use Manual

Installation instructions
22
Fasten the unit from the outside with PVC adhesive tape. Seal off the unit as much as possible by pulling the tape
tight.
NOTICE
Damage to the receptacle
Sealing resin inside the receptacle can damage the latter. Resin dissolves the material of the receptacle. Do not
let resin leak into the receptacle.
INFORMATION
Ensure that the cable connection points in the right direction: Knee joint cable towards the electronics, electron­
ics cable towards the battery.
Turn the casing such that you can see the inside of the receptacle. Mix a small amount of sealing resin with a suffi­
cient amount of hardener. Do not add too much hardener, since this could cause the resin to form bubbles during
hardening and make the connection brittle. Bond the receptacle to the casing. In order to do so, let the sealing res­
in flow gently and slowly around the receptacle into the recess (see fig. 24).
24
Then glue in the battery receptacle. Put the casing aside for hardening. Finish the orthosis: Mount the knee and, if
applicable, the ankle joint and attach inner pads and closures.

3.3 Final assembly

Remove the electronics and battery dummies from their receptacles.
NOTICE
Risk of short circuit
Do not insert the battery until the entire system has been assembled.
First connect both cables to the electronics receptacle (see fig. 25 to see fig. 28).
14
23
17B203=* E-MAG Active