Otto Bock E-MAG Active 17B203 Instructions For Use Manual page 15

25
27
Then connect the electronics cable to the battery. Place three to four small strips of double-sided adhesive tape –
depending on cable length – into the cable channel. Glue the cable into the casing (see fig. 29). You may shorten
the battery cable in the battery plug section. Leave approximately 5 cm additional cable length to allow for installa­
tion of the locking unit (see fig. 30). Ensure proper polarities (see fig. 31/see fig. 32): plus cable (red) to plus
connection (+ symbol on battery), minus cable (grey) to minus (no symbol).
INFORMATION
Please ensure that the full cable cross-section is maintained after shortening.
29
17B203=* E-MAG Active
26
28
30
marked red
Installation instructions
15