Provisioning Prerequisites; Introduction - Cisco BTS 10200 Softswitch Manual

Preparing for Dial Plan Provisioning
Revised: December 9, 2008, OL-8001-10

Introduction

This chapter describes the prerequisite tasks you need to perform before you can begin provisioning a
dial plan. It also describes the tools you will use, and provides detailed information on the dial plan
parameters and syntax conventions that you will need to be familiar with as you create your dial plan.
This chapter includes the following sections:
•
•
•
The Cisco BTS 10200 Softswitch can use two servers, an active and a standby, for maximum reliability.
Note
The dial plans discussed in this chapter apply to both the active and standby server. You need only create
one dial plan and deploy that dial plan on both the active and standby server.
The following sections describe recommended practices to assist you in provisioning dial plans for the
Cisco BTS 10200 Softswitch.

Provisioning Prerequisites

This section describes the tasks that must be completed and the information that you need before you
start dial plan provisioning.
OL-8001-10
Provisioning Prerequisites
Provisioning Tools
Creating a Dial Plan
C H A P T E R
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
5
5-1