Varchar(16): 1-16 Ascii Characters; Valid For Command: Add, Change, Audit, Sync, Show - Cisco BTS 10200 Softswitch Manual

Policy Based Flexible Routing
POLICY_TYPE
POP_ID
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
2-82
Description: Points to the next policy type table to use in the sequence.
Policy routing continues until policy-type=route or policy-nxx is reached.
All policy-types except route point to the Policy-$type table where $type =
odr | tod | percent | prefix | oli | pop | nxx. If policy-type = route, the Route
table is used for routing. The policy-id indexes the Policy or Route table,
whatever the case may be.
VARCHAR(7): 1-7 ASCII characters. Permitted values are:
CC—Circuit Code based routing
CTYPE—Call Type based routing
NXX—Use translated DN.
ODR—Origin Dependent Routing.
OLI—Originating line information.
PERCENT—Percentage based routing
POP—Point of presence.
PREFIX—Prefix-based routing.
REGION—Region-based routing.
ROUTE—Go to Route table.
TOD—Time-of-day routing.

Valid for Command: add, change, audit, sync, show

Mandatory: add
Possible Value: TOD, PERCENT, PREFIX, OLI, POP, ROUTE, NXX,
REGION
Parser: TextParser
Description: Primary key. Foreign key: Point of Presence table. The pop-id
assigned to the subscriber profile or the incoming trunk group to be used.

VARCHAR(16): 1-16 ASCII characters.

Valid for Command: add, change, show, delete, audit, sync
Mandatory: add, change, delete
Possible Value: [1_16]
Parser: TextParser
Chapter 2 Routing
OL-8001-10