Call Types; Interlata Call - Cisco BTS 10200 Softswitch Manual

Chapter 4 Command Line Interface Routing

Call Types

This section provides detailed information on the CLI usage for the Cisco BTS 10200 Softswitch call
types. CLI information on the following call types is provided:
•
•
•
•
•

1+ Interlata Call

This section provides a detailed description of the Cisco BTS 10200 Softswitch routing and call flow for
1+ interlata calls and provides CLI example references. Refer to
the 1+ interlata call routing flow while reviewing the following detailed step-by-step 1+ interlata call
routing flow.
A 1+ interlata call is received.
Step 1
Examples:
Subscriber Test1
Dp50 Digit-String = 202
Determine if a 101XXXX number has been dialed. If a 101XXXX number has been dialed, the Cisco
Step 2
BTS 10200 Softswitch will select the call route and route the call based on the carrier access code (CAC).
If a 101XXXX number has not been dialed, proceed to Step 3.
Check the subscriber table to determine if a PIC is defined. If a PIC is defined, the Cisco BTS 10200
Step 3
Softswitch will select the call route and route the call based on the PIC information. If a PIC is not
defined, proceed to Step 4.
Example:
Subsciber and Sub-Profile
Check the point of presence (POP) table and verify if a block-eawopic is configured. If the a
Step 4
block-eawopic is configured, the Cisco BTS 10200 Softswitch will block the call. If a block-eawopic is
not configured, proceed to Step 5.
Examples:
POP 50 No Block
POP 50 Block
OL-8001-10
1+ Interlata Call
1+ Intralata Call
0+ Interlata Call
0+ Intralata Call
Ported-In Call Processing
Figure 4-5
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
Call Types
for visual representation of
4-11