Provisioning Operator Services - Cisco BTS 10200 Softswitch Manual

Call Types
These calls can be terminated to another type of trunk group such as ISDN, SS7, and SIP, but in these
Note
cases the calls are treated as regular calls.

Provisioning Operator Services

To provision operator services, perform the following steps:
Add the CAS trunk group profile and the operator trunk group.
Step 1
add cas-tg-profile id=cas-OPS0; type=MO-10II; oss-sig=y; test-line=n;
add trunk-grp id=1500; tg-type=CAS; dial-plan-id=dpcas; sel-policy=LRU;
direction=outgoing; glare=ODD; tg-profile-id=cas-OPS0; call-agent-id=CA166; status=oos;
Step 2 Add the operator trunk terminations to the Termination Prefix table.
add termination prefix=cas/ops/mo/; mgw-id=224.14:2434; type=TRUNK; mgcp-pkg-type=MO;
port-start=1; port-end=24;
add trunk cic-start=5; cic-end=8; tgn-id=1500; termination-prefix=cas/ops/mo/;
mgw-id=224.14:2434; termination-port-start=5; termination-port-end=8;
Step 3 Add the operator routes.
add route id=ops1500; tgn1-id=1500; lcr=y;
add route-guide id=ops1500; policy-type=route; policy-id=ops1500;
Add the carrier ID and put the carrier in service.
Step 4
add carrier id=0510; intra=y; intl=y; route-guide-id=ops1500; use-dial-plan=y;
change carrier id=0510; status=ins;
Add the destination IDs.
Step 5
add destination dest-id=ops-toll; call-type=toll; route-type=ROUTE;
route-guide-id=ops1502; zero-plus=y;
add destination dest-id=ops-interlata; call-type=interlata; route-type=ROUTE;
route-guide-id=ops1501; zero-plus=y;
add destination dest-id=ops-intl; call-type=intl; route-type=ROUTE;
route-guide-id=ops1503; zero-plus=y;
add dial-plan id=dpcas; digit-string=817-313; reqd-digits=10; dest-id=ops-toll;
Add the dial plan and international dial plan.
Step 6
add dial-plan id=dpcas; digit-string=404-313; reqd-digits=10; dest-id=ops-interlata;
add intl-dial-plan cc=42; min-digits=6; max-digits=16; dest-id=ops-intl;
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
2-38
Chapter 2 Routing
OL-8001-10