C H A P T E R 5 Preparing For Dial Plan Provisioning; Prerequisite Tasks; Prerequisite Information - Cisco BTS 10200 Softswitch Manual

Provisioning Prerequisites

Prerequisite Tasks

The following steps describe the tasks you should perform prior to using this dial plan guide.
Plan and diagram your network configuration in detail.
Step 1
A detailed network diagram is essential when creating a dial plan. Refer to the respective solution
overview and provisioning documentation for detailed information about a particular solution.
Set up the Cisco BTS 10200 Softswitch and install all required software.
Step 2
Before you start the dial planning process, you should prepare the Cisco BTS 10200 Softswitch as
described in the following manuals:
•
•
•
•
•
•
•
Step 3 Complete all provisioning worksheets and site surveys, including filling in the names and IP addresses
of all devices, attributes, and all other necessary information.

Prerequisite Information

Before you can complete the dial plan provisioning, you must collect the Cisco BTS 10200 Softswitch
dial plan provisioning information.
•
•
•
•
•
•
•
•
•
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
5-2
Site Preparation and Network Communications Requirements
Network Site Survey for Software Installation Cisco BTS 10200 Softswitch
Cisco BTS 10200 Softswitch Building Environment and Power Site Survey
Cisco BTS 10200 Softswitch Cabling, VLAN, and IRDP Procedures
Cisco BTS 10200 Softswitch CD Jumpstart Procedure for Solaris 10 Based Duplex Systems
Cisco BTS 10200 Softswitch Application Installation
Cisco BTS 10200 Softswitch Provisioning Guide
id—dial plan identification
dest_id—destination identification
digit_string—dial plan digit string
max_digits—maximum number of digits
min_digits—minimum number of digits
noa—nature of address
split_npa—split number plan area
del_digits—deleted digits
pfx_digits—prefix digits
Table 5-1 provides space for you to enter the following information:
Chapter 5 Preparing for Dial Plan Provisioning
OL-8001-10