Lnp Route; Lnp Trigger = Y - Cisco BTS 10200 Softswitch Manual

Command Line Interface Routing Examples

LNP Route

The LNP Route CLI example is used in the
LNP Route Example:
CLI>show dial-plan id=dp50;digit-string=214-387
Reply : Success: Entry 1 of 1 returned.
ID=dp50
DIGIT_STRING=214387
DEST_ID=out
SPLIT_NPA=NONE
MIN_DIGITS=10
MAX_DIGITS=10
NOA=NATIONAL
CLI>show destination dest-id=local-sub
Reply : Success: Entry 1 of 1 returned.
DEST_ID=out
CALL_TYPE=LOCAL
ROUTE_TYPE=ROUTE
ROUTE_GUIDE_ID=test
ZERO_PLUS=N
INTRA_STATE=Y
GAP_ROUTING=N

LNP Trigger = Y

The LNP Trigger = Y CLI example is used in the
LNP Trigger = Y Example:
CLI>show dn2subscriber OFFICE_CODE_INDEX=657;dn=1000
Reply : Success: Entry 1 of 1 returned.
OFFICE_CODE_INDEX=657
DN=1000
STATUS=ASSIGNED
RING_TYPE=1
LNP_TRIGGER=Y
NP_RESERVED=N
SUB_ID=test1
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
4-32
Chapter 4
Ported-In Call Processing
Ported-In Call Processing
Command Line Interface Routing
routing examples.
routing examples.
OL-8001-10