Provisioning A Dial Plan With The Command Line Interface; Introduction; Dial Plan - Cisco BTS 10200 Softswitch Manual

Provisioning Dial Plans
Revised: December 9, 2008, OL-8001-10

Introduction

This chapter provides detailed instructions for configuring Cisco BTS 10200 Softswitch configuration
dial plans using the Command Line Interface (CLI) and the Cisco Extensible Provisioning and
Operations Manager (EPOM). The following subjects are discussed:
•
•

Provisioning a Dial Plan with the Command Line Interface

This section provides the detailed instructions for managing dial plans in the Cisco BTS 10200
Softswitch configuration using the CLI. The CLI also allows you to perform show, add, change, and
delete dial plans. The following subjects are discussed:
•
•
•
•
•
•

Dial Plan

Dial plans analyze, screen, and route calls based on dialed digits. The Dial Plan (dial-plan) table holds
dial plan information for a specific type of call. It defines valid dialing patterns and determines call
routing. All records that share a common dial-plan-profile id are considered a dial plan. For additional
Dial Plan table information, refer to the
OL-8001-10
Provisioning a Dial Plan with the Command Line Interface
Provisioning a Dial Plan with the Extensible Provisioning and Operations Manager
Dial Plan
Dial Plan Profile
International Dial Plan
International Dial Plan Profile
Custom Dial Plan
Custom Dial Plan Profile
C H A P T E R
"Dial Plan" section on page
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
6
1-45.
6-1