Cause Code Map; Cause Code Map Profile; H.323 Gateway; H.323 Gateway To Gatekeeper - Cisco BTS 10200 Softswitch Manual

Tandem Provisioning

Cause Code Map

The Cause Code Map (cause-code-map) table processes cause codes received from an outgoing
interface, and also when sending cause codes to a previous switch over an incoming interface. It also
specifies why a call was released.
When used for an outgoing interface, this table serves the following purposes:
•
•
When used for an incoming interface, the table maps normalized cause codes to a cause code sent over
the incoming interface. If no entry is found in the table, the Cisco BTS 10200 Softswitch uses the cause
code as is.

Cause Code Map Profile

The Cause Code Map Profile (cause-code-map-profile) table defines cause code map IDs, defines default
mappings to a standard cause code (Q.850), and defines default actions to take. These IDs must be
provisioned before provisioning either the Cause Code table or the Trunk Group table.

H.323 Gateway

The H.323 Gateway (h323-gw) table defines the capabilities of each H.323 protocol gateway. There can
be four instances of an H.323 gateway running on the Call Agent at any one time.

H.323 Gateway to Gatekeeper

The H.323 Gateway to Gatekeeper (h323-gw2gk) table describes gatekeeper characteristics for each
gateway in an H.323 network. Multiple gateways can have the same gatekeeper, or there can be a
different gatekeeper for each gateway. However, a gateway can be registered to one gatekeeper at a time.
A gatekeeper identifies, controls, counts, and supervises gateway traffic, including, but not limited to,
gateway registration, address resolution, bandwidth control, and admission control.

H.323 Terminal

The H.323 Terminal (h323-term) table holds information about H.323 terminals (such as H.323
audio/video phones) managed by the Call Agent and known in advance. This table is specific to H.323
subscribers.

H.323 Terminal Profile

The H.323 Terminal Profile (h323-term-profile) table defines the characteristics of group of H.323
terminals (or phones). An h323-term-profile id must be created in this table before any H.323 subscriber
entries can be added. This table contains almost all the same fields as from the H.323 Trunk Group
Profile table, except for some that are specific to trunk side (such as Generic Transparency Descriptor
(GTD)).
Cisco BTS 10200 Softswitch Dial Plan Guide, Release 4.5.x
3-18
Determines what action the Cisco BTS 10200 Softswitch takes for cause codes received over an
outgoing interface.
Maps received cause codes to normalized cause codes.
Chapter 3 Dial Plans and Routing
OL-8001-10